Filter Builder Revert button greyed out

SIGGIS Helpdesk (esri Support)

06 Juni 2024 08:31

Hi VertiGIS,

We want to verify how the Revert button was intended to be used, or how it should behave.

The documentation states: Revert: Returns the map to its previous state.

But it appears that it returns the previous state of the added conditions instead. As you add a (or several)  condition(s), the Revert button becomes clickable and reverts you back to the state where there were no conditions added yet.

If you apply the condition(s), the Revert button is greyed out. From the docu description however, we would expect that the button would be clickable in this situation to return to the map state before conditions applied. Isn't this what was intended?

To return the map ‘before the filter', we now have to clear the filters and Apply again. This works, but it puzzles us what use there is for the Revert button…

1

• 

  S. Burgert

  28 Januari 2025 16:09

  Any ideas on that or is there the possibility to change the behavior or buttons?

  0

Du måste logga in om du vill lämna en kommentar.