Buffer Geometry on only one side

Aaron Wong

29 November 2023 19:23 Redigerad

Hi Community,

Trying to create a workflow that would allow folks to draw a line, but only buffers to one side of the line instead of both sides. Is that possible?

Thanks,

Aaron

0

• 

  Berend Veldkamp

  05 December 2023 15:56 Redigerad

  You could try to buffer the line as usual, then extend the line, and use that with the Cut Geometry activity.

  Note that there is no Extend activity, but it should be possible to use a web request with a geometry service's trimExtend endpoint

  0

Du måste logga in om du vill lämna en kommentar.