Zoom to point

Permanently deleted user

29 Augusti 2012 20:02

Hi,

 

 

I've created a workflow that selects a point based on the ID entered by the user.

 

I'm encountering problems while trying to zoom to this point. The output should only be one point.

 

 

So far my other workflows have zoomed to polygons no problem, but I can't seem to figure out why they won't zoom to a point.

 

If someone could post a workflow that I can open in Workflow Designer, that would be a great help!

Thanks

0

• 

  Permanently deleted user

  29 Augusti 2012 23:33

  Hi Lauren,

  I had the exact same problem.

  See thread

  (https://support.geocortex.com/essentialsGSCForum?sub-nav=forum&main-nav=essentials&feedtype=SINGLE_QUESTION_DETAIL&criteria=ALLQUESTIONS&id=90660000000091vAAA) Set MapExtent (Point Feature)

  Thx to Mr. Ralph Price!

   

  0
• 

  Permanently deleted user

  30 Augusti 2012 01:14

  Lauren,

  There was a discussion related to zooming to a point a while ago.  Check out the last post in this thread:  http://support.geocortex.com/Forums/Thread.aspx?pageid=0&mid=2&ItemID=7&thread=45526&pagenumber=2

  I think the example workflow might be what you are looking for:  (http://support.geocortex.com/Data/Sites/1/media/forumfiles/bufferedzoom.zip) http://support.geocortex.com/Data/Sites/1/media/forumfiles/bufferedzoom.zip 

  Steve

  0
• 

  Permanently deleted user

  30 Augusti 2012 01:48

  Thanks for your help guys,

   

  I tried the buffered example and it works great!

   

  The other workflow was too confusing for my limited programming expertise!

  0
• 

  Permanently deleted user

  14 Februari 2013 07:30

  Yes, it worked fine :)

  Thanks you so much Ralph, appreciate your prompt & helpful reply

   

  Basu

   

  0

Du måste logga in om du vill lämna en kommentar.