Show query results in table view but keep identify results in list view

Permanently deleted user

17 Januari 2019 09:57

Hello,

I have a workflow that use SwitchToTabularResultsView or ShowResultTable in to display layer query results in the table view. However, if I then use Identify Tool, the result is also displayed as table. I have to click the hamburger button of the table view to manually switch it to List View. This is not very convince from user point of view. Is there a way to display Query results in table view, but let Identify Tool still display results in list view (so I could still see the configured Short / Long Discretion etc.)? Thanks.

0

• 

  Amanda Frech

  25 Januari 2019 17:01

  Hi Jack,

   

  Would you be able to post in the ideas section of the support center? https://support.geocortex.com/GSCIdeas?c=09a6000000008RsAAI&filter=1&categ=all&sub-nav=ideas&main-nav=essentials&page=1

   

  Technically this is an Html5 viewer issue- the ShowResultsTable and ShowResultsList commands switch the viewer's results "mode", and I haven't found any workarounds to get the behaviour you're describing (either through workflow or through the viewer's results module configuration). We already have an internal request to improve the documentation for how this command currently works.

   

  For an idea post, you'd want to request a new command that does what ShowResultsTable does, but without switching the results "mode" for future selections.

  0
• 

  Permanently deleted user

  28 Januari 2019 23:54

  Thanks Amanda. I have post the idea here.

  https://support.geocortex.com/essentialsGSCIdeasDetail?c=09a6000000008RsAAI&id=087f2000000TjrRAAS&categ=all&sub-nav=ideas&main-nav=essentials

   

  0

Du måste logga in om du vill lämna en kommentar.