With workflow 5, after modifying a workflow with the designer, can I retest it in viewer without a page refresh, like old workflow? Currently it seems that I have to always refresh the whole page which is quite painful

Permanently deleted user

January 23, 2018 04:49

0

• 

  Stefan Schweigert

  January 23, 2018 06:05

  Hello Zhijie,

   

  Yes, this is supported. If you load GVH with &debug=true at the end of the URL then you will be able to make changes to your workflow and run it without the need for refreshes.

   

  Thanks, Stefan

  0
• 

  Permanently deleted user

  January 23, 2018 06:30

  Thanks a lot, works wonderfully

  0
• 

  Nelson Dobbs

  January 24, 2018 22:59

  @Stefan Schweigert?  @Zhijie Shen? &dev=true works as well.

   

  Stefan, whats the difference the debug and the dev parameters?

  0
• 

  Stefan Schweigert

  January 24, 2018 23:07

  They are the same to my knowledge, either can be used in this case.

  0
• 

  Permanently deleted user

  February 14, 2019 16:03

  @Stefan Schweigert?  and @Nelson Dobbs?: I found the difference. Debug is logging just about every data binding that the viewer executes, while dev just logs the workflows.

   

  You can see the difference pretty easily in client console. Open a new tab and open the console, then navigate to a viewer in dev mode. Then, change your dev to debug. If you watch your memory usage while performing this exercise I think that the practical implication for workflow development is clear.

  0

Please sign in to leave a comment.