The scale bar that prints from GC5 Print templates is not correct. The scale of the map is, though.

Is there a way to lock the scale bar to a scale? Right now, it looks like it is just arbitrarily sized and then chopped in half for labels. Because of this, none of the divisions are correct, much less one inch long.

If I choose 1" = 50' as an output, it puts a scale bar that is 100 something long and the halfway (50) tic mark is only 3/4".

If i output the same area at 1" = 100', the scale bar grows to 300, divided in half at 150 which ends up being 1 1/8", not 1 1/2".

The scale of the actual map is dead on though.

We are outputting our maps in Web Mercator...is that the problem?

How do I get the scale bar to output so it measures correctly?

The scale bar that prints from GC5 Print templates is not correct. The scale of the map is, though.

Comments

Didn't find what you were looking for?